Pharmaceutical-Grade BAC Water | Houston, TX | HPLC-Tested | COA Every Order
What Is Peptide Reconstitution?
Peptide reconstitution is the process of dissolving a lyophilized (freeze-dried) peptide powder into a liquid solvent — typically bacteriostatic water — to create an injectable solution. Lyophilized peptides are shipped in powder form for stability and shelf-life; they must be reconstituted before use in research protocols.
What You Need for Peptide Reconstitution
Before starting, gather the following: USP-grade bacteriostatic water (0.9% benzyl alcohol), your lyophilized peptide vial with stated mg amount, a sterile 1mL insulin syringe, alcohol swabs, and a reconstitution calculator result. Never shake a reconstituted peptide — always swirl gently.
Step-by-Step Reconstitution Protocol
Step 1 — Calculate your volume: Use the Renew Lab Group reconstitution calculator. Enter your peptide amount in mg and your desired concentration (e.g. 2mg/mL). The calculator outputs exactly how many mL of bacteriostatic water to add.
Step 2 — Swab both vials: Wipe the rubber stopper of the bacteriostatic water vial and the peptide vial with a fresh alcohol swab. Allow 60 seconds to air-dry completely before proceeding.
Step 3 — Draw bacteriostatic water: Insert the syringe needle through the center of the BAC water stopper. Withdraw the exact calculated volume slowly. Remove the syringe.
Step 4 — Inject along the glass wall: Insert the needle into the peptide vial at a 45-degree angle. Slowly push the BAC water in by letting it run down the inside wall of the glass — never inject directly onto the peptide cake. This prevents foaming and degradation.
Step 5 — Swirl gently to dissolve: Gently swirl (never shake) the vial between your palms until the powder fully dissolves. The solution should be clear. If cloudiness persists, allow more time — do not shake.
Step 6 — Label and store: Mark the vial with today’s date. Refrigerate at 2–8°C. Discard 28 days after first entry.
How Much Bacteriostatic Water Should I Use?
The volume of bacteriostatic water depends on your desired final concentration. For example: a 5mg peptide vial reconstituted with 2.5mL of bacteriostatic water creates a 2mg/mL solution. Use the free Renew Lab Group reconstitution calculator to get the exact mL for your target concentration and dose volume.
Written by
Naomi Crabtree
Quality Assurance Specialist & Research Consultant · Renew Lab Group
Naomi specializes in pharmaceutical quality assurance, HPLC analysis, and USP compendial testing. She oversees Certificate of Analysis verification and research compliance for Renew Lab Group’s bacteriostatic water products.
